Welcome to Sharetop Technology Co.,ltd.
Hotline:+86-0755-27524036
share
  qq space Sina Weibo Renren Tencent Weibo Netease Weibo More platforms




100Gb/s CFP2 ER4 40km

Category:100Gb/s CFP2 ER4 40km Optical Transceiver
Code:CFP/CFP2/CFP4 Business Module

 - Products description -


       Sharetop’s100G_CFP2 ER4, The 100G CFP2 ER4 optical transceiver integrates the transmit and receive path onto one module. On the transmit side, four lanes of serial data streams are recovered, retimed,and passed on to four laser drivers, which control four electric-absorption modulated lasers (EMLs) with 1296, 1300, 1305, and 1309 nm center wavelengths. The optical signals are then multiplexed into a single-mode fiber through an industry-standard LC connector.On the receive side, four lanes of optical data streams are optically demultiplexed by an integrated optical demultiplexer. Each data steam is recovered by a PIN photodetector and transimpedance amplifier, retimed, and passed on to an output driver. This module features a hot-pluggable electrical interface, low power consumption, and MDIO management interface.


 - Product Features -


Supports up to 112Gbps bit rates

Duplex LC connector

Hot pluggable

Operating electrical serial data rate up to 27.952493Gbps

APDROSA

4 parallel electrical serial interface

Applicable for 30km SMF connection

Low power consumption, < 12W

Digital Diagnostic Monitor Interfacel

MDIO Communication Interface

Compliant with 100GBASE-ER4

Operating case temperature:

Commerical:0 to 70 °C


 - Product Specification -


Local Area Network(LAN)

Wide Area Network(WAN)

Switch to router interface


Standards


Compliant with IEEE 802.3ba

Compliant with CFP2 MSA hardware specifications

Compliant with CFP2 MSA management specifications

Compliant with ITU-T G709/Y.1331

Compliant with RoHS

Specification

Optical Characteristics

(Tested under recommended operating conditions,unless otherwise noted)

Parameter

Symbol

Unit

Min

Typ

Max

Notes

Optical Transmitter Characteristics

Signaling rate, each lane


GBd

25.78125 ±100 ppm

100GBase-ER4

27.9525 ±20 ppm

OTU4

Four Lane Wavelength Range

λ1

nm

1294.53

1295.56

1296.59


λ2

1299.02

1300.05

1301.09


λ3

1303.54

1304.58

1305.63


λ4

1308.09

1309.14

1310.19


Total launch power


dBm



8.9

100GBase-ER4

Average launch power, each lane

Pavg

dBm

-2.9


2.9

2

Optical modulation amplitude, each lane (OMA)2

OMA

dBm

0.1


4.5


Difference in launch power between any two lanes (OMA)


dB



3.6


Extinction ratio

ER

dB

8



100GBase-ER4

Side-mode suppression ratio

SMSR

dB

30




Transmitter and dispersion penalty, each lane

TDP

dB



2.5


Optical return loss tolerance


dB



20


Transmitter reflectance3


dB



–12


Transmitter eye mask {X1, X2, X3, Y1, Y2, Y3}



{0.25, 0.4, 0.45, 0.25, 0.28, 0.4}

100GBase-ER4

Optical Receiver Characteristics

Receive Rate for Each Lane


Gbps


25.78125

27.9525


Overload Input Optical Power

Pmax

dBm

5.5



3

Average Receive Power for Each

Lane

Pin

dBm

-20.9


4.5

4, 5

Receive Power In OMA for Each

Lane

PinOMA

dBm



4.5


Difference in Receive Power in

OMA between Any Two Lanes


dBm



4.5


Receiver Sensitivity in OMA for

Each Lane

SOMA

dBm



-21.4

6

Stressed Receiver Sensitivity in

OMA for Each Lane


dBm



-17.9

7, 8

Notes:

1. The supply current includes CFP2 module’s supply current and test board workingcurrent.

2. Average launch power, each lane (min) is informative for 100GBase-LR4, not the principal indicator of signal strength.

3.The receiver shall be able to tolerate , without damage, continuous exposure to an optical input signal having this average power level

4. The average receive power , each lane (max) for 100GBASE-ER4 is larger than the 100BASE-ER4 transmitter value to allow compatibility with 100BASE-LR4 units at short distances

5. Average receive power, each lane (min) is informative and not the principal indicator

of signal strength. A received power below this value cannot be compliant; however, a value above this does not ensure compliance

6. Receiver sensitivity (OMA), each lane (max) is informative

7. Measured with conformance test signal at TP3 for BER=10-12

8. conditions of stressed receiver sensitivity test: vertical eye closure penalty for each lane is 1.8dB;stressed eye J2 jitter for each lane is 0.3UI; stressed eye J9 jitter for each lane is 0.47UI.


Ordering Information

Part Number

Description

XYT--100G_CFP2 ER4

CFP2 100G ER4 40Km 0~70℃


Sale service

Products damaged due to human or non-use of other causes of improper,we promises one year warranty and lifetime maintenance,but the unauthorized disassembly equipment caused damage is not covered under warranty and returned within range.
Under normal use,if there are product quality problems,or not work normally,we provide free repair or replacement service within one year;Within three years more than one year,we provide to collect the material cost,maintenance free.
Repair warranty period of three years from the freight borne by each of the parties.After three years of warranty,the material cost,maintenance,freight(refers to the product of the two-way shipping to and from)shall be borne by the user.
We promise that the product we provide can meet the performance requirements of users , and it is supplied by the user's sample request.

Technical Support

No FIle
Common services
About us
Payment issue
After-sales service
Co-operatives
  • 0755-27524940
  • 0755-27524036
Privacy Policy   |   Copyright   |   Online message   |   Site map   |   sitemap   |   Download   |  Hot line:+86-0755-27524036  |   Subscribe
ShenZhen Sharetop Technology Co.,Ltd. Copyright ? 2010-2015 poptimes CO.,Ltd. All rights reserved.