- Products description -
Sharetop’s 100G CF P2 LR4 or ER4 optical receiver integrates the 4 receive paths onto one module. On the receive side, 4 lanes of optical data streams are optically demultiplexed by an integrated optical demultiplexer. Each data steam is recovered by a PIN photodetector or APD and transimpedance amplifier, retimed, and passed on to an output driver. This module features a hot-pluggable electrical interface, low power consumption, and MDIO management interface.
- Product Features -
Supports up to 112Gbps bit rates
Duplex LC connector
Hot pluggable
PIN or APD ROSA
Operating electrical serial data rate up to 27.952493Gbps
4 parallel electrical serial interface
Applicable for 10km(PIN) or 30km(APD) SMF connection
Low power consumption, < 3W
Digital Diagnostic Monitor Interfacel
MDIO Communication Interface
Compliant with 100GBASE-LR4,ER4 and OTU4
Operating case temperature
Commerical:0 to 70 °C
- Product Specification -
Local Area Network(LAN)
Wide Area Network(WAN)
Switch to router interface
ITU-T OTU4 OTL4.4
Standards
Compliant with IEEE 802.3ba
Compliant with CFP2 MSA hardware specifications
Compliant with CFP2 MSA management specifications
Compliant with ITU-T G709/Y.1331
Compliant with RoHS
Optical Characteristics
(Tested under recommended operating conditions,unless otherwise noted)
Parameter | Symbol | Unit | Min | Typ | Max | Notes | |||
Optical Receiver Characteristics | |||||||||
Receive Rate for Each Lane | Gbps | 25.78125 | 27.9525 | ||||||
Overload Input Optical Power | Pmax | dBm | 5.5 | 3 | |||||
Average Receive Power for Each Lane | Pin | dBm | -8.6 + ∆ | 3 | 4, 5 | ||||
Receive Power In OMA for Each Lane | PinOMA | dBm | 3 | ||||||
Difference in Receive Power in OMA between Any Two Lanes | dBm | ||||||||
Receiver Sensitivity in OMA for Each Lane (PIN) | SOMA1 | dBm | -8.6 | 6 | |||||
Receiver Sensitivity in OMA for Each Lane (APD) | SOMA2 | dBm | -16 | 6 | |||||
Stressed Receiver Sensitivity in OMA for Each Lane(PIN) | dBm | -6.8 | 7, 8 | ||||||
Stressed Receiver Sensitivity in OMA for Each Lane(APD) | -13 | 7, 8 |
Notes:
1. The supply current includes CFP2 module’s supply current and test board workingcurrent.
2. Average launch power, each lane (min) is informative for 100GBase-LR4, not the principal indicator of signal strength.
3.The receiver shall be able to tolerate , without damage, continuous exposure to an optical input signal having this average power level
4. The average receive power , each lane (max) for 100GBASE-ER4 is larger than the
100BASE-ER4 transmitter value to allow compatibility with 100BASE-LR4 units at short distances
5. Average receive power, each lane (min) is informative and not the principal indicator
of signal strength. A received power below this value cannot be compliant; however, a value above this does not ensure compliance
6. Receiver sensitivity (OMA), each lane (max) is informative
7. Measured with conformance test signal at TP3 for BER=10-12
8. conditions of stressed receiver sensitivity test: vertical eye closure penalty for each lane is 1.8dB;stressed eye J2 jitter for each lane is 0.3UI; stressed eye J9 jitter for each lane is 0.47UI.
Ordering Information
Part Number | Description |
XYT--100G_CFP2-LR4 | CFP2 100G LR4,PIN Receiver 0~70℃ |
XYT--100G_CFP2-ER4 | CFP2 100G ER4,APD Receiver 0~70℃ |
隐私保护 |
法律声明 |
在线留言 |
网站导航 |
网站地图 |
文档下载 | 咨询热线:0755-27524036 |
订阅
深圳纤亿通科技有限公司版权所有 转载必究 Copyright 2010-2019 poptimes CO.,Ltd. All rights reserved.
备案号:粤ICP备14020946号
友情链接: 光创未来| fiber168| 纤亿通光源放大器网站| 纤亿通光模块网站| 纤亿通保偏无源器件网站| 纤亿通OTN网站