首页 > 产品 >Optic Transceiver Module>QSFP28 100G>100G ER4

联系我们

联系我们

0755-23334940 0755-27524036

企业邮箱

sales001@xyt-tech.com

公司地址

深圳南山区西丽文苑路35号聚创金谷创意园A栋606

: 100Gb/s CFP2 ER4 Lite 30km

产品分类：100G ER4
产品编号：100Gb/s CFP2 ER4 Lite 30km Optical Transceiver

立即咨询

产品概述
产品特性
产品应用
产品参数

- Products description -

Sharetop’s100G_CFP2 ER4 Lite, The 100G CFP2 ER4 optical transceiver integrates the transmit and receive path onto one module. On the transmit side, four lanes of serial data streams are recovered, retimed,and passed on to four laser drivers, which control four electric-absorption modulated lasers (EMLs) with 1296, 1300, 1305, and 1309 nm center wavelengths. The optical signals are then multiplexed into a single-mode fiber through an industry-standard LC connector.On the receive side, four lanes of optical data streams are optically demultiplexed by an integrated optical demultiplexer. Each data steam is recovered by a PIN photodetector and transimpedance amplifier, retimed, and passed on to an output driver. This module features a hot-pluggable electrical interface, low power consumption, and MDIO management interface.

- Product Features -

Supports up to 112Gbps bit rates

Duplex LC connector

Hot pluggable

Operating electrical serial data rate up to 27.952493Gbps

APD ROSA

4 parallel electrical serial interface

Applicable for 30km SMF connection

Low power consumption, < 12W

Digital Diagnostic Monitor Interfacel

MDIO Communication Interface

Compliant with 100GBASE-ER4

Operating case temperature

Commerical:0 to 70 °C

- Product Specification -

Local Area Network(LAN)

Wide Area Network(WAN)

Switch to router interface

Standards

Compliant with IEEE 802.3ba

Compliant with CFP2 MSA hardware specifications

Compliant with CFP2 MSA management specifications

Compliant with ITU-T G709/Y.1331

Compliant with RoHS

- 产品参数 -

Optical Characteristics

(Tested under recommended operating conditions,unless otherwise noted)

Parameter	Symbol	Unit	Min		Typ			Max			Notes
Optical Transmitter Characteristics
Signaling rate, each lane		GBd	25.78125 ±100 ppm						100GBase-ER4
			27.9525 ±20 ppm						OTU4
Four Lane Wavelength Range	λ1	nm	1294.53	1295.56		1296.59
	λ2		1299.02	1300.05		1301.09
	λ3		1303.54	1304.58		1305.63
	λ4		1308.09	1309.14		1310.19
Total launch power		dBm				8.9			100GBase-ER4
Average launch power, each lane	Pavg	dBm	-2.9			2.9			2
Optical modulation amplitude, each lane (OMA)2	OMA	dBm	0.1			4.5
Difference in launch power between any two lanes (OMA)		dB				3.6
Extinction ratio	ER	dB	8						100GBase-ER4
Side-mode suppression ratio	SMSR	dB	30
Transmitter and dispersion penalty, each lane	TDP	dB				2.5
Optical return loss tolerance		dB				20
Transmitter reflectance3		dB				–12
Transmitter eye mask {X1, X2, X3, Y1, Y2, Y3}			{0.25, 0.4, 0.45, 0.25, 0.28, 0.4}						100GBase-ER4
Optical Receiver Characteristics
Receive Rate for Each Lane		Gbps		25.78125			27.9525
Overload Input Optical Power	Pmax	dBm	5.5							3
Average Receive Power for Each Lane	Pin	dBm	-16				4.5			4, 5（-20.9）
Receive Power In OMA for Each Lane	PinOMA	dBm					4.5
Difference in Receive Power in OMA between Any Two Lanes		dBm					4.5
Receiver Sensitivity in OMA for Each Lane	SOMA	dBm					-16			6（-21.4）
Stressed Receiver Sensitivity in OMA for Each Lane		dBm					-12			7, 8（-17.9）

Notes:

1. The supply current includes CFP2 module’s supply current and test board workingcurrent.

2. Average launch power, each lane (min) is informative for 100GBase-LR4, not the principal indicator of signal strength.

3.The receiver shall be able to tolerate , without damage, continuous exposure to an optical input signal having this average power level

4. The average receive power , each lane (max) for 100GBASE-ER4 is larger than the 100BASE-ER4 transmitter value to allow compatibility with 100BASE-LR4 units at short distances

5. Average receive power, each lane (min) is informative and not the principal indicator

of signal strength. A received power below this value cannot be compliant; however, a value above this does not ensure compliance

6. Receiver sensitivity (OMA), each lane (max) is informative

7. Measured with conformance test signal at TP3 for BER=10-12

8. conditions of stressed receiver sensitivity test: vertical eye closure penalty for each lane is 1.8dB;stressed eye J2 jitter for each lane is 0.3UI; stressed eye J9 jitter for each lane is 0.47UI.

Ordering Information

Part Number	Description
XYT--100G_CFP2 ER4 Lite	CFP2 100G ER4 Lite 30Km 0~70℃

联系我们

100Gb/s CFP2 ER4 Lite 30km

相关产品